This blog documents our attempt to construct a ventilator design for use in a Flu Pandemic that can be made from readily available materials at the last minute. Hopefully, the situation never arrives where this device will need to be used for a pandemic. But just in case... The Post below is the most recent. See the right side panel for other posts. This Blog was started on Feb 22, 2007
Sunday, April 1, 2007
New Bellows Design and Magnetic Sensors
Here is the new bellows design. It is open at the ends and sides to prevent wear on the bag. I also taped the seams of the bag for extra strength. It is clamped into place, and the clamp provides strain relief for the tape seal along the open end of the bag. The upright section on the left has the two magnetic sensors duct taped to it.
No comments:
Post a Comment
Commenting has been limited for this post
Note: Only a member of this blog may post a comment.